CVE-2026-79980
Predictable and reused DHCPv4 transaction identifier allows spoofed DHCP replies to reconfigure gateway and DNS
Что произошло
The DHCPv4 client in subsys/net/lib/dhcpv4/dhcpv4.c maintained its transaction identifier (iface->config.dhcpv4.xid) as a counter rather than as a per-transaction random value. It was seeded once with sys_rand32_get() in dhcpv4_start_internal(), incremented by one in dhcpv4_send_discover() and dhcpv4_send_decline(), and never changed by dhcpv4_send_request() — so every RENEWING and REBINDING exchange reused, unchanged, the identifier that had already appeared on the wire in the broadcast DHCPDISCOVER at boot, and where the identifier did move it moved predictably by one. RFC 2131 4.1 requires a single identifier per transaction, chosen so that clients are unlikely to collide. This identifier is the client's only unpredictable reply-validation token. net_dhcpv4_input() accepts a BOOTP reply on op, a matching xid, and a matching chaddr (the interface MAC, which is public); the UDP callback is registered with a wildcard remote address and port, and no server-identifier or source-address check is applied. An attacker who learns one identifier — for example any host on the same segment that sees the broadcast DHCPDISCOVER, or a DHCP server or relay on a network the device previously joined — therefore retains a valid token for the device's whole uptime, and can predict the identifiers of later exchanges, without having to observe the unicast renew traffic or race the legitimate server. A forged reply that passes those checks has effect regardless of client state, because dhcpv4_parse_options() applies its side effects before the state machine gate in dhcpv4_handle_reply(): the router option calls net_if_ipv4_set_gw() and the DNS option calls dns_resolve_reconfigure(). A single accepted datagram can thus repoint the device's default gateway and resolvers at attacker-controlled addresses, redirecting its traffic; during RENEWING or REBINDING a forged DHCPACK re-binds the lease with attacker-chosen parameters and a forged DHCPNAK removes the address and restarts configuration. The fix draws a fresh sys_rand32_get() value at each point where a transaction begins — entering SELECTING, RENEWING and REBINDING, and at the INIT/INIT-REBOOT entry taken when an interface with a lease goes down — while REQUESTING and DECLINE keep the identifier of the exchange they belong to, as RFC 2131 requires. As a side effect the client also no longer discards a slow server's offer after retransmitting a discover, and the initial-discover backoff now draws its own randomness instead of deriving it from the identifier.
Что это значит
В источнике описана ошибка безопасности в перечисленных продуктах. Фактический риск зависит от установленной версии, конфигурации и доступности компонента; проверьте условия в первичном бюллетене.
Что делать
1. Проверьте, затронуты ли вы
Соберите инвентаризацию и сравните с таблицей затронутых версий. Эти команды только показывают установленные компоненты и сами по себе не доказывают наличие CVE.
dpkg-query -W -f='${Package} ${Version}\n'rpm -qa --qf '%{NAME}\t%{VERSION}-%{RELEASE}\n'Get-HotFix | Select-Object HotFixID, InstalledOn
2. Установите исправление
Сверьте точный продукт и версию с бюллетенем вендора. Установите указанное в нём исправление после резервного копирования и проверки совместимости. Подтверждённая целевая версия в источниках отсутствует.
3. Временные меры
До проверки бюллетеня ограничьте доступ к затронутому компоненту доверенными узлами. Оцените сегментацию и отключение ненужных интерфейсов с владельцем сервиса; универсального правила WAF для этой CVE не подтверждено.
4. Проверьте следы эксплуатации
Проверьте аномальные входы, новые учётные записи, ошибки и необычные дочерние процессы в затронутом сервисе. Публичные проверенные правила обнаружения не включены в запись; отсутствие сигналов не доказывает отсутствие компрометации.
5. После исправления
- Проверьте фактическую версию и результат установки по бюллетеню.
- При необходимости перезапустите сервисы в согласованное окно.
- Повторите проверку сканером и функциональные проверки.
- Зафиксируйте результат, дату, владельца и оставшийся риск.
Продукты и затронутые версии
zephyrproject / zephyr
{
"status": "affected",
"version": "1.7.0",
"lessThan": "4.5.0",
"versionType": "semver"
}CVSS: оценки и векторы
CVSS 3.1 · cve5.6
CVSS:3.1/AV:N/AC:H/PR:N/UI:N/S:U/C:L/I:L/A:L
CVSS 3.1 · vulnerabilities@zephyrproject.org5.6
CVSS:3.1/AV:N/AC:H/PR:N/UI:N/S:U/C:L/I:L/A:L
Источники и ссылки
Происхождение полей
{
"cwes": [
"cve",
"nvd"
],
"epss": {
"source": "epss",
"received_at": "2026-11-03T21:15:14.364647+00:00"
},
"title": {
"source": "cve",
"received_at": "2026-11-02T14:08:40.043225+00:00"
},
"scores": [
"cve",
"nvd"
],
"status": {
"source": "cve",
"received_at": "2026-11-02T14:08:40.043225+00:00"
},
"affected": [
"cve"
],
"published": {
"source": "cve",
"received_at": "2026-11-02T14:08:40.043225+00:00"
},
"solutions": [],
"percentile": {
"source": "epss",
"received_at": "2026-11-03T21:15:14.364647+00:00"
},
"references": [
"cve",
"nvd"
],
"description": {
"source": "cve",
"received_at": "2026-11-02T14:08:40.043225+00:00"
},
"workarounds": [],
"configurations": []
}Хронология записи
- Данные обновлены04.11.2026, 00:15
- Данные обновлены03.11.2026, 00:14
- Данные обновлены02.11.2026, 00:12
- Данные обновлены31.10.2026, 11:59
- Появились сведения об исправлении28.10.2026, 20:19
- Данные обновлены28.10.2026, 18:06
- Опубликована28.10.2026, 15:16
Личная заметка и статус
Другие CVE того же продукта
| УЯЗВИМОСТЬ / ПРОДУКТ | ПРИОРИТЕТ | CVSS | EPSS | СИГНАЛЫ | ОПУБЛИКОВАНА | Карточка |
|---|---|---|---|---|---|---|
| CVE-2026-87044 Memory leak in the Mbed TLS crypto shim on failed cipher/AEAD operations leads to remotely triggered crypto denial of service zephyrproject / zephyr | Средний | 6.5 | — | Патч | 04.11.2026 | |
| CVE-2026-87043 sys_rand_get() silently returns an unwritten buffer when the entropy device is not ready zephyrproject / zephyr | Средний | 4.8 | — | Патч | 04.11.2026 | |
| CVE-2026-87041 Inverted memory-permission check in the RTIO syscall verifier allows a user-mode thread to read and write arbitrary kernel memory zephyrproject / zephyr | Высокий | 7.8 | — | Патч | 04.11.2026 | |
| CVE-2026-87040 Bluetooth LE Controller accepts received PDUs whose length field exceeds the configured maximum receive length, causing out-of-bounds read and write zephyrproject / zephyr | Высокий | 8.3 | — | Патч | 04.11.2026 | |
| CVE-2026-87039 I2S configure syscall handler passes an unvalidated user-supplied kernel object pointer to drivers zephyrproject / zephyr | Высокий | 7.8 | — | Патч | 04.11.2026 |